HQ Power HQLE10010 Mode D'emploi page 4


Never connect the device to a dimmer or rheostat.

Never carry or move the device from the power cord or any other moving part.
Always use the bracket.

In the event of an operating problem, stop using the device immediately.

Never try to repair the device. There are no user-serviceable parts inside the device.
Refer to an authorized dealer for service and/or spare parts.

This device is not designed for permanent operation: regular operation breaks will
prolong its live.

Indoor use only. Keep this device away from rain, moisture, splashing and dripping
liquids. Never put objects filled with liquids on top of or close to the device.

This device is not suitable for ordinary lighting in household room illumination.
3. Warranty

Refer to the Velleman

All modifications of the device are forbidden for safety reasons. Damage caused by user
modifications to the device is not covered by the warranty.

Only use the device for its intended purpose. Using the device in an unauthorised way will void
the warranty.

Damage caused by disregard of certain guidelines in this manual is not covered by the warranty
and the dealer will not accept responsibility for any ensuing defects or problems.

Nor Velleman nv nor its dealers can be held responsible for any damage (extraordinary, incidental
or indirect) – of any nature (financial, physical...) arising from the possession, use or failure of this
product.
4. Installation
4.1 General Guidelines

Have the device installed by a qualified person, respecting all applicable norms.

Install the device on an even, fire-resistant, scratch-resistant, water-resistant and
non-slippery surface.

The carrying construction must be able to support 10 times the weight of the device
for 1 hour without deforming.

Make sure there is no flammable material within a 1 m radius of the device.

Install the device in a location with few passers-by that is inaccessible to
unauthorised persons.

Install the device in a location where you can easily access the power cord.

Install the device in a well-ventilated area.
4.2 Overhead Installation

When hung, the device must always be secured with a secondary attachment e.g. a
safety cable.

Never stand directly below the device when it is being mounted, removed or serviced.
Have a qualified technician check the device once a year and once before you bring it
into service.

Overhead mounting requires extensive experience: calculating workload limits,
determining the installation material to be used... Have the material and the device
itself checked regularly. Do not attempt to install the device yourself if you lack these
qualifications as improper installation may result in injuries.

For truss mounting, use an appropriate clamp (not incl.) and fit an M10 bolt through
the centre of the (folded) bracket.
V. 02 – 10/11/2017
HQLE10010
®
Service and Quality Warranty on the last pages of this manual.
4 ©Velleman nv