Fulgor Milano CREATIVE CH 1004 ID TS Mode D'emploi page 38

be activated. The power button only can be
used (Power) to turn off the Touch Control
(and restart the procedure).
GB
Permanent unlock
The hob zone display of the front right hob
zone (FR) and the special Power Booster
(P) must be simultaneously pressed, then
press the special Power Booster again.
This procedure must be completed within 10
seconds and no other key must be pressed
except for that mentioned. The Touch
Control remains in the Off mode (all displays
are blank), failing which the procedure is
cancelled and the Touch Control switches
to Off mode after 20 seconds.
If the control unit is activated by pressing
the ON/OFF key, all displays will show the
"0" symbol, the dots on the display continue
to flash and the command unit can be used
for cooking. In the presence of the hot hob
zone warning lights [H], this message is
displayed alternately with [0] and at the
same time with the dot on the display.
Acoustic signalling (buzzer)
The following activities carried out during
the operation of the Touch Control are
signalled by a buzzer:
– Single brief acoustic signal for the regular
activation of a key. The acoustic signal is
only emitted on the first activation for the
Slider area. No acoustic signal is emitted
during the modification of the values.
– A longer intermittent acoustic signal for
the permanent use of the keys for a more
prolonged period (> 10 seconds
– Timer time-out
All manuals and user guides at all-guides.com
Timer function
There are two different types of timer
function available:
– Independent
acoustic signal with timing. This function
can be activated only if there are no other
hob zones functioning (all levels = 0). If
any of the hob zones are activated (level
>0) the independent timer remains active.
If the timer must be used to switch off a
cooking area (see timer for cooking area),
then the command must first be turned off
and on.
– Hob zone timer 1.99 minutes: This
function can be activated as long as a hob
is on (level < 0; dot on the display). Four
cooking areas to be deactivated are freely
programmable timer and beep.
Setting a timer value
– Adjustment by means of the slider area.
– The adjustment of the first digit usually
occurs first, followed by the adjustment of
the second digit.
– Within 10 seconds after setting the second
digit, the value might reset (the dot on the
timer display and when there is a specific
timer for a hob zone the assigned LED
flashing).
– For the display of the active timer, the
timer value can be set to [0] by directly
pressing [0] on the slider (left side).
Deactivation of an active timer
– A timer can be deactivated by setting the
value to 0.
– An independent timer can be deactivated
through the double activation of the power
key (1st TC active, 2nd TC and Timers
off).
38
Timer 1.99 minutes: