Fulgor Milano CREATIVE CH 1004 ID TS Mode D'emploi page 36

Automatic heat-up function
When the automatic heat-up function
is activated the wattage of the cooking
zone is at 100% for a certain heat-up time
which is dependent on the setting selected
GB
(continuous).
At the end of the heat-up time the electronic
control switches back to the preselected
simmering setting.
Starting process of the automatic heat-
up
- The control is ON and a cooking zone will
be selected
- When the power level 9 is reached
the automatic
through a further press of the slider in
correspondence with the maximum value.
- The required power level is selected by
means of the slider and the selected
value is shown on the display.
- At this point, you can select the level
required for the continuation of the
cooking using the Slider area. The symbol
"A" appears 3 seconds after the button is
released, alternating with the continuation
level.
- The continuation level can be changed
within 15 seconds from activation without
disabling the precooking boost. So, you
must select the cooking area and then set
the corresponding cooking area.
- If the selection takes place after 15
seconds:
You can select a higher continuation level;
this implies that the precooking time will
automatically be aligned to the currently
selected continuation level.
All manuals and user guides at all-guides.com
heating is activated
Precooking
Cooking
level
0
u
1
2
3
4
5
6
7
8
9
Residual heat indicator
It is meant to indicate to the user that the
glass ceramic has a dangerous touch
temperature in the circumference of a
cooking zone. The temperature will be
determined following
model and the remaining residual heat
will be indicated by means of "H" on the
corresponding 7-segment display.
Heating up and cooling down will be
calculated dependent on
• The selected setting ("0" to "9")
• The ON/OFF time of the relays
• After switching OFF the cooking zone
the respective display shows "H" until
the assigned cooling zone temperature
is mathematically in an uncritical level. (<
60°C).
Automatic switch-off (limited operating
time)
Maximum operating time is defined for each
hob zone. The maximum operating time
depends on the selected cooking level (see
table). Once the maximum operating time
36
Maximum
Boost A operating
[min] time [h]
0 0
0 6
1 6
3 6
4,8 5
6,5 5
8,5 4
2,5 1,5
3,5 1,5
4,5 1,5
0,2 1,5
a mathematical