Publicité
Les langues disponibles
Les langues disponibles
Product Information
H Installation and use
▶ Do not install the device below a socket or near curtains or
other combustible materials.
▶ Do not use the heating near a bathtub, shower or swimming
pool.
▶ Do not use the product in small rooms if these are used by
persons who are not able leave the room by themselves,
unless the room is continuously monitored.
H Hot surface
Some parts of this product can become very hot and inflict
burns when they come into contact with the skin. Proceed with
extreme caution if children and vulnerable adults are present.
H Risk of overheating, risk of fire
To reduce the risk of fire:
▶ Maintain a clearance of at least 1 m between the air outlet
and textiles, curtains or other combustible materials.
▶ Do not place anything on the convector. Do not cover the
convector or climb onto it.
▶ Ensure that the heat transfer from the convector is
unhindered.
▶ Only use the product on a horizontal stable surface or
fasten it to the wall.
H Danger to life from electric shock!
Touching a defective product or connecting lead may result in
electric shock.
▶ Do not use the product if it has been dropped.
▶ Do not use the product if there are visible signs of damage.
▶ Do not open the product.
▶ Avoid carrying out any interventions.
▶ Stop using the product and disconnect it from the mains
power supply.
▶ Please contact Service.
You can find the service addresses in chapter 10, page 63.
-or-
▶ Dispose of the product properly.
2
Product Information
These instructions contain important information for the
system user regarding safe operation of the Heat Convector
4000.
The convector must only be set up or mounted outside the
safety zone (shown in grey Fig. 15, page 65).
For this:
▶ observe the installation instructions.
54
2.1
Declaration of conformity
The design and operating characteristics of this product
comply with the European and national requirements.
The CE marking declares that the product complies
with all the applicable EU legislation, which is
stipulated by attaching this marking.
The complete text of the Declaration of Conformity is available
on the Internet: www.bosch-thermotechnology.com.
2.2
Scope of delivery
▶ Check packaging upon receipt of delivery for damage.
▶ Check the scope of delivery for completeness.
– Heat Convector 4000
– Technical documentation
2.3
Definition
The Heat Convector 4000 is subsequently referred to in this
document as "product", "convector" or "appliance".
2.4
Intended use
The convector is intended for heating of living spaces.
▶ Comply with the connection conditions in accordance with
the specifications, standards and regulations of the
relevant country.
▶ The convector must only be set up or mounted outside the
safety zone (shown in grey Fig. 15, page 65).
Any other purpose is considered improper use. Any damage
that results from such use is excluded from liability.
2.5
Product description
The Heat Convector 4000 is a wall mounted or floor standing
electric plate space heating convector ( Fig. 13, page 64).
Legend for figure 13, page 64:
[1] Convector
[2] Display
[3] On/Off switch
3
Commissioning
If the appliance is installed or set up in or was previously stored
in a much colder environment, it must be allowed to adjust to
the room temperature.
▶ Wait half an hour before switching on the appliance.
When the appliance is heating for the first time, it may emit a
slightly unpleasant odour (for 2 hours at the most) which is
caused by the product residues drying out.
Heat Convector 4000 – 6720883017 (2022/12)
Publicité
