Kenwood SW-38HT Mode D'emploi page 7

Controls and indicators
1
Notes:
1. Do not increase the output of the amplifier to a high level while the low-frequency level is enhanced by the amplifier's tone
control or loudness control.
2. When operating the amplifier switches or when placing the stylus on an analog record, set the amplifier volume to its minimum
level.
Specifications
Type ...................... Subwoofer system with built-in amplifier
[Amplifier]
Dynamic Power ................................................. 100 W (6Ω)
(For U.S.A. and Canada)
Rated Output Power (FTC)
75 W RMS, at 6 Ω 150 Hz, with no more than 0.7 % T.H.D.
Input Sensitivity & Input Impedance ........ 200 mV (43 kΩ)
Rated Power Consumption ........................................ 70 W
Frequency Responce ................................... 35 Hz ~ 200 Hz
(For other countries)
Rated Output Power ....................... 75 W RMS (150 Hz,6Ω)
Input Sensitivity & Input Impedance ........ 200 mV (43 kΩ)
Rated Power Consumption ........................................ 70 W
Frequency Responce ................................... 35 Hz ~ 200 Hz
Notes:
1. Kenwood follows a policy of continuous advancements in development. For this reason, specifications may be changed without
notice.
2. Full performance may not be exhibited in extremely cold locations (below 0 deg. C).
1 POWER ON indicator
2
2 LINE INPUT jack (RCA-type pin-plug)
This jack is used to connect the subwoofer Pre-Out
jack of the amplifier.
3
3 VOLUME control knob
Adjusts the volume level of the output of the Subwoofer.
Rotating the knob clockwise increases the volume level,
and rotating the knob counterclockwise decreases the
volume level.
4
4 POWER switch
Switches the power ON and OFF .
5
5 Power cord
Connect to AC outlet.
Caution concerning operation
An excessive input level to the Subwoofer may impair the sound
quality or damage the unit. Careful attention should therefore
be paid to the following precautions.
Caution: Read this page carefully to ensure safe operation.
[Speaker]
Enclosure .......................... Bass-Reflex, Floor Standing Type
Speaker Units ............................ 160 mm (6-1/2") Cone type
Nominal Impedance ....................................................... 6 Ω
Dimensions
Width ................................................... : 210 mm (8-1/4 ")
Height ................................................ : 400 mm (15-3/4 ")
Depth ................................................. : 350 mm (13-3/4 ")
Net Weight .................................................... 9.2 kg (20.3 lb)
Supplied accessories
Pin-plug cord .................................................................. 1
NOTE: THE GRILLE CANNOT BE REMOVED.
7
EN