GLÄSS AUDIO DESK SYSTEME VINYL CLEANER PRO Mode D'emploi page 31

All manuals and user guides at all-guides.com
6.4.1 Extremely dirty records
If records are extremely dirty, you might want to extend the cleaning process.
In order to extend the cleaning time, keep the start button (14) pressed down until
you hear a signal.
Each signal you hear while pressing down the start button extends the cleaning
time by one minute. It is possible to extend the time by a maximum of five minutes
(five signals).
Interrupting the drying process
6.4.2
The drying process is initiated automatically after completion of the cleaning
process.
The standard drying process takes approximately 4 minutes as determined by
the software.
In the event that the record dries before the completion of the normal drying
cycle, it is possible to terminate the drying process by pushing the start button.
An audible signal will indicate that it is now safe to remove the record.
The repeatable drying process (see 6.4.3 below) cannot be interrupted!
6.4.3 Repeating the drying process
The drying process can be repeated if there are still water drops on the record after
the normal cleaning cycle.
Keep the start button (14) pressed down.
– After 6 audible signals the drying process (approximately 2 minutes) will
start automatically.
6.4.4 Removing the record
To remove the record, press the edge of the record
down gently with your right hand, then using a clock-
wise motion pull out the record with your left hand.
Make sure that the record does not touch the wet
cleaning barrels.
31