Andis SMC Instructions D'utilisation Et D'entretien page 4

OPERATING INSTRUCTIONS
Plug cord into electrical outlet, operate at 120 volt, 60 cycle AC electrical current or as
noted on the unit.
5-SPEED OPERATION
Your clipper is equipped with five cutting speeds. The speeds are adjusted using the
arrows on either size of the power button (Figure A). Lower speeds are recommended
for use on your dog's face, belly, under the tail, and on puppies or dogs that are new
to grooming. Higher speeds are recommended for use on your dog's body coat and
for dogs that are comfortable being groomed. To start your clipper, press the power
button. To increase your blade speed, press the up arrow. To decrease your blade
speed, press the down arrow. To shut your clipper off, press the power button. After
using your clipper, rewrap cord, and store in a safe place.
REMOVING BLADE SET
To remove blade set, first make sure your clipper motor is switched OFF. Push blade
release mechanism under blade hinge (Figure B). While holding down the blade
release mechanism, push down on blade, then gently pull the blade forward (Figure C),
and slide it off the blade hinge. If your blade hinge should snap closed and is flush
with the clipper, use a small standard screwdriver to pry the tongue of the hinge out
(Figure D). NOTE: Hair may accumulate in the front cavity of the housing under the
blade. If this happens, you can clean out the hair by brushing out the cavity with a
small brush or an old toothbrush while the blade is off the clipper.
REPLACING OR CHANGING BLADE SET
To replace or change your blade set, slide the blade bracket onto the hinge of the
clipper (Figure E) and with the clipper turned ON, push the blade towards the clipper
to lock into position.
USER MAINTENANCE
The internal mechanism of your motor clipper has been permanently lubricated by
the factory. Other than the recommended maintenance described in this manual,
no other maintenance should be performed, except by Andis Company, or an Andis
authorized service station. To find an Andis authorized service station near you log
on to andis.com or contact our customer service department: 1-800-558-9441.
4