Kübler CODIX 924-6 Mode D'emploi page 33

All manuals and user guides at all-guides.com
Pressing the Prog/Mode key
acknowledges this prompt and
terminates the programming; the
modified settings are saved in
the EEPROM.
Õ
7.8.1 Default parameters
Note: Three default parameter
sets have been permanently
stored; these can be adapted as
required. With each
acknowledgment of the
parameter sets, all parameters
will be reset to the values listed
in the table.
The dEFAuL P.USEr can be
freely programmed.
Menu Parameter Sets
Default setting
Parameter set 1
Default setting
Parameter set 2
Default setting
Parameter set 3
Freely programmable
User settings
Factory settings are highlighted
in grey
www.kuebler.com
The text SAVE is
displayed for 2 s
7.8.2 Table: Parameter Sets
P.SEt 1
Func Count
InP.PoL PnP
FiLtEr on
Count Cnt.dir
MPi LAtch
Loc.InP ProG
ModE Add
FActor 01.0000
diViSo 01.0000
dP 0
SEtPt 000000
CoLor red.Grn
rESmd Man.EL
Pr.Out 1
t.Out 1
Pr.Out 2
t.Out 2
Pr.Out 3
t.Out 3
Pr.Out 4
t.Out 4
Pr.Out 5
t.Out 5
Pr.Out 6
t.Out 6
7.8.3 Setting the Basic Function
Basic function menu
Programming menu
Pulse counter (7.8.4)
Programming menu
Timer/Hour meter (7.8.6)
Programming menu
Tacho/Frequency meter (7.8.5)
P.SEt 2 P.SET 3
Count Count
PnP PnP
oFF oFF
uP.dn Quad
LAtch Set
ProG ProG
Sub AddAr
01.0000 01.0000
01.0000 01.0000
0 0.00
000000 0000.00
red.Grn red.Grn
Man.EL Man.EL
00.10
00.10 00.10
00.10
00.10
00.10
00.10
Page 7