nama SJ200 Mode D'emploi page 21

19
HOPPER GASKET
Located on the bottom of the hopper, this gasket
helps to seal the hopper to the chamber.
To remove, hold the silicone ring and pull
downwards.
To install, pull the silicone ring upwards so it fits
into its groove. You may need to stretch the ring
as you work your way around the circle.
CHAMBER GASKET
Located in the center of the chamber, this gasket
seals the chamber around the drive shaft.
To remove, hold the silicone ring and pull upwards
from one side.
To install, press one side of the ring into the slot
first, and then work your way around the circle.
Be sure to check the ring is a smooth circular
shape without any folds or bunches.
SPINNING BRUSH BLADES
Located on the spinning brush, these blades wipe
the outside of the strainer and the inside of the
chamber at the same time.
To remove, hold the inside of the blade and pull
inwards to the center of the ring.
To install, slide the blade through the slot from
inside to outside. Then, pull the blade outwards,
until it locks into place.