nama SJ200 Mode D'emploi page 20

18
SILICONE PARTS
The silicone parts can be disassembled for deep cleaning. These are
not necessary to remove each time you use the juicer.
PULP OUTLET GASKET
Located inside the pulp outlet, this gasket helps
to separate the pulp from the juice.
To remove, hold the silicone piece and pull
upwards or away from the outlet.
To install, match the corners with the profile of
the pulp outlet and press down firmly into place.
PULP OUTLET SEAL GASKET
Located inside the pulp outlet, this gasket helps
to seal the pulp outlet.
To remove, hold the silicone piece and pull
upwards or away from the outlet.
To install, hold the silicone piece upright, fit into
the slot, and press firmly into place.
JUICE CAP STOPPER
Located inside the juice outlet, this is used to
stop or control the flow of juice.
To remove, pull the silicone stopper starting from
one corner.
To install, insert one edge of the plastic juice cap
into the silicone stopper and then press around
the perimeter.