Black & Decker BDCD8 Instructions Originales page 6

ENGLISH
• Hold power tool by insulated gripping
surfaces when performing an operation
where the cutting accessory may
contact hidden wiring. Cutting
accessory contacting a "live" wire may
make exposed metal parts of the power
tool "live" and could give the operator an
electric shock.
• Hold power tool by insulated gripping
surfaces, when performing an operation
where the fastener may contact hidden
wiring. Fasteners contacting a "live" wire
may make exposed metal parts of the
power tool "live" and could give the
operator an electric shock.
• Use clamps or another practical way to
secure and support the workpiece to a
stable platform. Holding the work by
hand or against your body leaves it
unstable and may lead to loss of control.
• Before drilling into walls, floors or
ceilings, check for the location of wiring
and pipes.
• Avoid touching the tip of a drill bit just
after drilling, as it may be hot.
• The intended use is described in this
instruction manual. The use of any
accessory or attachment or performance
of any operation with this tool other than
those recommended in this instruction
manual may present a risk of personal
injury and/or damage to property.
Safety of others
• This tool is not intended for use by
persons (including children) with
reduced physical, sensory or mental
capabilities, or lack of experience and
knowledge, unless they have been given
supervision or instruction concerning use
of the tool by a person responsible for
their safety.
• Children should be supervised to ensure
that they do not play with the appliance.
Residual risks
Additional residual risks may arise when
using the tool which may not be included in
the enclosed safety warnings. These risks
can arise from misuse, prolonged use etc.
Even with the application of the relevant
6
All manuals and user guides at all-guides.com
(Original instructions)
safety regulations and the implementation of
safety devices, certain residual risks can not
be avoided. These include:
• Injuries caused by touching any
• Injuries caused when changing any parts,
• Injuries caused by prolonged use of a
• Impairment of hearing.
• Health hazards caused by breathing dust
Vibration
The declared vibration emission values
stated in the technical data and the
declaration of conformity have been
measured in accordance with a standard test
method provided by EN 60745 and may be
used for comparing one tool with another.
The declared vibration emission value may
also be used in a preliminary assessment of
exposure.
Warning! The vibration emission value
during actual use of the power tool can
di er from the declared value depending on
the ways in which the tool is used. The
vibration level may increase above the level
stated.
When assessing vibration exposure to
determine safety measures required by
2002/44/EC to protect persons regularly
using power tools in employment, an
estimation of vibration exposure should
consider, the actual conditions of use and
the way the tool is used, including taking
account of all parts of the operating cycle
such as the times when the tool is switched
o and when it is running idle in addition to
the trigger time.
Labels on tool
The following symbols are shown on the tool
along with the date code:
rotating/moving parts.
blades or accessories.
tool. When using any tool for prolonged
periods ensure you take regular breaks.
developed when using your tool
(example:- working with wood, especially
oak, beech and MDF.)
Warning! To reduce the risk of injury,
the user must read the instruction
manual.