Braun 1 Serie Mode D'emploi page 10

If you regularly clean the shaver under water, then once a week apply a drop of
light machine oil onto the long hair trimmer (4) and shaver foil.
Model 150s only:
• Switch the shaver on and rinse the shaver head under hot running water.
• You may use liquid soap without abrasive substances. Rinse off all foam and let
the shaver run for a few more seconds.
• Next, switch off the shaver, remove the shaver foil (2) and cutter block (3).
Then leave the disassembled shaving parts to dry.
Model 130s only:
• After each shave, rinse the shaver head under hot running water (A).
You may use liquid soap without abrasive substances. Rinse off all foam.
• Next, remove the shaver foil (2) and cutter block (3). Then leave the
disassembled shaving parts to dry.
Alternatively, you may clean the shaver using the brush provided (B):
• Switch off the shaver. Remove the shaver foil and tap it out on a flat surface.
• Using the brush, clean the cutter block and the inner area of the shaver head.
However, do not clean the shaver foil with the brush as this will damage the foil.
Keeping your shaver in top shape
Replacing the shaver foil and cutter block
To maintain 100% shaving performance, replace the shaver foil (2) and cutter
block (3) at least every 18 months or when worn. Change both parts at the same
time for a closer shave with less skin irritation.
(Shaver foil and cutter block: 11B)
Environmental notice
Product contains batteries and/or recyclable electric waste. For environ-
ment protection do not dispose of in household waste, but for recycling
take to electric waste collection points provided in your country.
Subject to change without notice.
For electric specifications, see printing on the special cord set.
10
All manuals and user guides at all-guides.com