Publicité
Les langues disponibles
Les langues disponibles
BM 2610027607 06-13_BM 2610027607 06-13.qxp 6/4/13 11:29 AM Page 9
Disconnect the plug from
W RNING
the power source before
making any assembly, adjustments or
changing accessories. Such preventive
safety measures reduce the risk of starting
the tool accidentally.
SELECTING GRINDING ACCESSORIES
Before using a grinding wheel
W RNING
point or cone, be certain
that its maximum safe operating speed is
not exceeded by the nameplate speed of
the grinder. Do not exceed the recommended
wheel point or cone diameter.
INSTALLING ACCESSORIES
Be sure that the diameter of
W RNING
the shank is the same size
as the inside diameter of the collet.
To prevent damage to collet,
C UTION
avoid excessive tightening of
the collet nut when there is no accessory inserted.
Only use properly fitting and undamaged open-
end wrenches.
1. Place a open-end wrench onto the spindle
to prevent the spindle from rotating (Fig. 2).
Hold the tool with both
W RNING
hands while starting the
tool, since torque from the motor can
cause the tool to twist.
SLIDE ON-OFF SWITCH WITH LOCK
The tool is switched "ON" by the switch button
located at the side of the motor housing. The
switch can be locked in the "ON" position, a
convenience for long grinding operations.
TO TURN THE TOOL "ON" without locking it,
slide the switch button forward by applying
pressure ONLY at the REAR portion of the
button. When pressure is released the switch
button will snap to "OFF" position.
TO LOCK THE SWITCH "ON", slide the switch
button forward and press "IN" the FRONT
portion.
TO UNLOCK THE SWITCH, simply press and
release the REAR portion of the button.
Switch is spring loaded and will snap back
automatically.
All manuals and user guides at all-guides.com
Assembly
2. Hold wrench in place and rotate collet nut
3. Insert three fourths of shank of accessory
Repeat steps 1 and 2 of above and remove
accessory.
Operating Instructions
Your tool is equipped with an internal
electronic feedback system that provides a
"soft start", which will reduce the stresses that
occur from a high torque start. The system
also helps to keep the preselected speed
virtually constant between no-load and load
conditions.
This tool is equipped with a variable speed dial.
The speed may be controlled during operation
by presetting the dial in any one of six positions.
Setting
-9-
counter-clockwise with another open-end
wrench.
into the collet and securely tighten collet nut
clockwise.
REMOVING ACCESSORIES
FIG. 2
SPINDLE LOCK
WRENCH
SH NK OF
CCESSORY
COLLET
ELECTRONIC FEEDBACK
(Models DG250C, DG355LCE &
DG490CE only)
VARIABLE SPEED DIAL
(Models DG355LCE & DG490CE only)
Dial
RPM
DG355LCE
1
10,000
2
14,000
3
18,000
4
22,000
5
26,000
6
30,000
COLLET NUT
WRENCH
RPM
DG490CE
2,500
3,600
4,700
5,800
6,900
8,000
Publicité
