Pettec Remote Spray Trainer 3.0 Mode D'emploi page 25

Les langues disponibles

Using as an anti-bark trainer

Activating the anti-bark mode

Before you can use the training collar as an anti-bark trainer, you'll need to

activate the anti-bark mode – just turn on the training collar but don't operate

the remote control for a full minute. After one minute the training collar auto-

matically disconnects from the remote control, and you can use the collar as

an anti-bark trainer.

Note: Each time you turn on the training collar, you need to operate the remote

control within one minute in order to use the remote mode. Otherwise, the

anti-bark mode will remain active.

Sensitivity settings in the anti-bark mode

The device comes with three different sensitivity levels for the microphone:

low, medium, and high. The higher the sensitivity is set, the more easily the

training collar reacts to relatively soft barking. Conversely, when set at the

lowest setting, the collar normally reacts only to loud barking.

Note: The medium setting is normal sensitivity. You can change the micropho-

The medium setting is normal sensitivity. You can change the micropho-

ne sensitivity setting by briefly pressing the power switch on the collar.