KitchenAid KGCS105GSS Instructions D'utilisation page 2

Before you start...
Your safety and the safety of
others are very important.
We have provided many important
safety messages in this manual and
on your appliance. Always read and
obey all safety messages.
This is the safety alert
symbol.
This symbol alerts you to
potential hazards that can kill or hurt
you and others.
All safety messages will follow the
safety alert symbol and either the
word "DANGER" or "WARNING".
These words mean:
DANGER
You can be killed or seriously
injured if you don't immediately
follow instructions.
WARNING
You can be killed or seriously
injured if you don't follow
instructions.
All safety messages will tell you
what the potential hazard is, tell you
how to reduce the chance of injury,
and tell you what can happen if the
instructions are not followed.
Important: Observe all governing
codes and ordinances.
Tools needed for installation:
ruler or
tape measure
2
WARNING: If the
information in this manual
is not followed exactly, a
fire or explosion may result
causing property damage,
personal injury or death.
— Do not store or use
gasoline or other
flammable vapors and
liquids in the vicinity of
this or any other
appliance.
— WHAT TO DO IF YOU
SMELL GAS
• Do not try to light any
appliance.
• Do not touch any
electrical switch.
• Do not use any phone in
your building.
• Immediately call your
gas supplier from a
neighbor's phone. Follow
the gas supplier's
instructions.
• If you cannot reach your
gas supplier, call the fire
department.
— Installation and service
must be performed by a
qualified installer, service
agency or the gas
supplier.
Note: This cooktop is manufactured for
use with Natural gas. To convert to
L.P./Propane gas, see instructions in the
Gas Conversion Kit provided in literature
package.
Proper gas supply connection
available. See "Gas supply requirements,"
Page 4.
flat-blade
screwdriver
Proper installation is your responsibility.
Have a qualified technician install this
cooktop.
Make sure you have everything
necessary for correct installation. It is the
responsibility of the installer to comply
with the installation clearances specified
on the model/serial rating plate. The
model/serial rating plate can be found on
the underside of the cooktop burner box.
Check location where cooktop will be
installed. The location should be away
from strong draft areas, such as windows,
doors and strong heating vents or fans.
Do not obstruct flow of combustion and
ventilation air.
All openings in the wall or floor where the
cooktop is to be installed must be sealed.
When installing a cooktop under existing
cabinets and the installation does not
meet the minimum cabinet clearances,
install a range hood above the cooktop to
avoid burn hazards.
Electrical ground is required. See
"Electrical Requirements," Pages 4-5.
It is the customer's responsibility:
• To contact a qualified electrical
installer.
• To assure that electrical installation is
adequate and in conformance with
National Electrical Code, ANSI/NFPA
70 — latest edition*, or Canadian
Electrical Code, C22.1 -1982 and C22.2
No. 01982 (or latest edition)** and all
local codes and ordinances.
Copies of the standards listed may be obtained
from:
*National Fire Protection Association
** CSA International
must be
pliers
pencil
One Batterymarch Park
Quincy, Massachusetts 02269
8501 East Pleasant Valley Rd.
Cleveland, OH 44131-5575