GE PCB910 Manuel Du Propriétaire page 26

Special features of your oven control.
Your new touch pad control has additional features that you may choose to use. The following are the features
and how you may activate them.
The special feature modes can only be activated while the display is showing the time of day. They remain
in the control's memory until the steps are repeated.
When the display shows your choice, touch the START pad. The special features will remain in memory after
a power failure, except for the Sabbath feature, which will have to be reset.
(on some models)
26
12-Hour Shutdown
With this feature, should you forget
and leave the oven on, the control will
automatically turn off the oven after
12 hours during baking functions
or after 3 hours during a broil function.
If you wish to turn OFF this feature, follow
the steps below.
Touch the upper oven BROIL HI/LO
and BAKE pads at the same time until
the display shows SF.
Fahrenheit or Celsius Temperature Selection
Your oven control is set to use the
Fahrenheit temperature selections,
but you may change this to use
the Celsius selections.
Touch the upper oven BROIL HI/LO
and BAKE pads at the same time until
the display shows SF.
Tones at the End of a Timed Cycle
At the end of a timed cycle, 3 short beeps
will sound followed by one beep every
6 seconds until the CLEAR/OFF pad is
touched. This continual 6-second beep
may be cancelled.
To cancel the 6-second beep:
Touch the upper oven BROIL HI/LO
and BAKE pads at the same time until
the display shows SF.
Touch the BROIL HI/LO pad. The
display shows CONTI BEEP (continuous
beep). Touch the BROIL HI/LO pad
again. The display shows SINGLE BEEP.
(This cancels the one beep every 6
seconds.)
Touch the START TIME pad until
no shdn (no shut-off) appears in the
display.
Touch the START pad to activate
the no shut-off and leave the control
set in this special features mode.
Touch the COOK TIME and BROIL
HI/LO pads at the same time. The
display will show F (Fahrenheit).
Touch the COOK TIME and BROIL
HI/LO pads again at the same time.
The display will show C (Celsius).
Touch the START pad.
OR
Touch the TIMER ON/OFF pad.
The display shows CON BEEP
(continual beep). Touch the TIMER
ON/OFF pad again. The display
shows BEEP. (This cancels the one
beep every 6 seconds.)
Touch the START pad.