Publicité
Les langues disponibles
Les langues disponibles
3.2 E
C
LECTRICAL
ONNECTION TO
U
NIT
NOTE: To avoid miswiring, refer to the notes taken at step
.
terminal
Use the terminal connector included, by unplugging it fi rst, to perform the electrical connection for main wall control. Use
screws to fi x wires in the terminal connector. Check if all wires are fi rmly connected in their corresponding holes in the
terminal connector by slightly pulling on each wire.
Once the wall control connections have been made, insert the terminal connector in the electrical compartment.
Plug the ventilation unit and test the wall control.
VC0241
3.3 E
C
LECTRICAL
ONNECTION TO
VC0243
NOTE : The auxiliary wall control is connected to the same connector as the main wall control.
NOTE : The auxiliary wall control can be used with a 3-wire connection by removing the LED signals. This optional wiring
will not allow an installation with more than 1 auxiliary wall control to properly synchronize their LEDs on an event
requested from a peer. Only the auxiliary wall control having requested the timer event will have the LEDs updated
accordingly.
NOTE : For more information about the installation and operation of the auxiliary wall control, refer to the included
Installation and User Guide, which is also available at www.venmar.ca.
A
M
W
UTOMATIC
AIN
ALL
B
V
OTTOM
IEW
20-40-60 O
PTIONAL
C
(
.41404)
ONTROL
PART NO
T
ERMINAL
of section 3.1 to match the wire color with the right
12V
D-
D+
Gnd
A
W
C
UXILIARY
ALL
ONTROL
12V
LED
OVR
Gnd
13
C
ONNECTOR
12V
D-
D+
Gnd
(
.204060R)
PART NO
12V
LED
OVR
Gnd
Publicité
