Publicité
Les langues disponibles
Les langues disponibles
B. Wall mounting: installation of the charging base
Warning! Check the type of partition or wall on which you want to
attach the charging base.
Please buy the screws adapted to your wall or partition (drywall,
plaster, hollow brick, etc.).
Make sure that no installation, such as electrical wiring and piping,
is present in the wall. It is your responsibility to ensure that the wall
can safely support the full load of the appliance and its accessories.
If necessary, use qualified personnel for the wall installation.
Incorrect assembly can lead to personal injury and material damage.
The vacuum cleaner is supplied without a hardware kit for wall-mounting the charging
base. This installation requires 2 screws max diameter 3 mm and the dowels suitable
for the material of the wall or partition on which to install the plinth.
Proceed as shown as below:
1
Place the charging base against the wall in
the desired location and mark two points
on the wall with a pencil, checking their
alignment. The two holes should be 5 cm
apart. Drill the two holes using an electric
drill (not supplied).
2
Insert the two dowels (not supplied) into
the holes.
44
Publicité
