Publicité
Les langues disponibles
Les langues disponibles
CHARGING pROCEDURE
The standard charger provided will charge a fully depleted battery in
about 4 hours.
1. Plug the charger into an appropriate outlet before inserting the
battery pack.
2. Insert the battery pack into the charger as shown in figure 1.
3. The green leD will flash indicating
that the battery is being charged.
4. The completion of charge is
indicated by the green leD remaining
on continuously. The pack is fully
charged and may be used at this time
or left on the charger.
Recharge discharged batteries as
soon as possible after use or battery
life may be greatly diminished. It is
recommended that the batteries be
recharged after each use.
LEAVING THE bATTERY IN THE CHARGER
The charger and battery pack can be left connected with the green
leD glowing indefinitely. The charger will keep the battery pack
fresh and fully charged.
ImpORTANT CHARGING NOTES
1. longest life and best performance can be obtained if the battery
pack is charged when the air temperature is between 60°F and 80°F
(16°- 27°c). DO NOT charge the battery pack in an air temperature
below +40°F (+4.5°c), or above +105°F (+40.5°c). This is important
and will prevent serious damage to the battery pack.
2. The charger and battery pack may become warm to touch
while charging. This is a normal condition, and does not indicate a
problem. To facilitate the cooling of the battery pack after use, avoid
placing the charger or battery pack in a warm environment such as
in a metal shed, or an uninsulated trailer.
3. If the battery pack does not charge properly:
a. check current at receptacle by plugging in a lamp or other
appliance
All manuals and user guides at all-guides.com
1
7
b. check to see if receptacle is connected to a light switch
which turns power off when you turn out the lights.
c. Move charger and battery pack to a location where the
surrounding
air temperature is approximately 60°F and 80°F(16°- 27°c)
d. If charging problems persist, take the tool, battery pack and
charger to your local service center.
4. The battery pack should be recharged when it fails to produce
sufficient power on jobs which were easily done previously. DO
NOT cONTINUe to use under these conditions. Follow the charging
procedure. You may also charge a partially used pack whenever you
desire with no adverse affect on the battery pack.
5. Foreign materials of a conductive nature such as, but not limited
to, steel wool, aluminum foil, or any buildup of metallic particles
should be kept away from charger cavities. always unplug the
charger from the power supply when there is no battery pack in the
cavity. Unplug charger before attempting to clean.
6. Do not freeze or immerse charger in water or any other liquid.
WARNING:
Shock hazard. Do not allow any liquid to get
inside charger. Never attempt to open the battery pack for any
reason. If the plastic housing of the battery pack breaks or cracks,
return to a service center for recycling.
ASSEmbLY INSTRUCTIONS
ASSEMBLY TOOLS REQUIRED (NOT SUPPLIED):
- Phillips Screwdriver
ATTACHING GUARD AND bAIL HANDLE TO TRImmER
WARNING:
Only use with handle and guard properly
assembled to hedge trimmer. The use of the hedge trimmer
without the proper guard or handle provided may result in
serious personal injury.
The trimmer is shipped with the guard and bail handle attached to
the trimmer with a plastic zip tie.
Publicité
