Black & Decker KC9024FB Mode D'emploi page 7

Additional safety instructions for batteries and
chargers
Batteries
Never attempt to open for any reason.
Do not store in locations where the
temperature may exceed 40 °C.
Charge only at ambient temperatures between
4 °C and 40 °C.
Charge only using the charger provided with
the tool (see technical data).
When disposing of batteries, follow the
instructions given in the section "Protecting
the environment".
Under extreme conditions, battery leakage
may occur. When you notice liquid on the
battery, proceed as follows:
- Carefully wipe the liquid off using a cloth.
Avoid skin contact.
- In case of skin or eye contact, follow the
instructions below.
The battery fluid, a 25-30% solution of
potassium hydroxide, can be harmful.
In case of skin contact, immediately rinse
with water. Neutralise with a mild acid such
as lemon juice or vinegar. In case of eye
contact, rinse abundantly with clean water
for at least 10 minutes. Consult a physician.
Fire hazard! Avoid short-circuiting the
contacts of a detached battery.
Do not incinerate the battery.
Chargers
Use your Black & Decker charger only to
charge the battery in the tool with which it was
supplied. Other batteries could burst, causing
personal injury and damage.
Never attempt to charge non-rechargeable
batteries.
Have defective cords replaced immediately.
Do not expose to water.
Do not open the charger.
All manuals and user guides at all-guides.com
Your charger has been designed for a specific
mains voltage. Always check that the mains voltage
corresponds to the voltage on the rating plate.
The pack contains:
1 Cordless screwdriver
1 Double-ended screwdriver bit
1 Charger
1 Instruction manual
1. On/off switch with forward/reverse function
2. Bit holder
3. Charger connector
4. Charger
5. Battery
Fitting and removing a screwdriver bit (fig. B)
Do not probe the charger.
The charger is intended for indoor use
only.
ELECTRICAL SAFETY
Your charger is double insulated in
accordance with EN 60335; therefore no
earth wire is required.
Never attempt to replace the charger unit
with a regular mains plug.
PACKAGE CONTENTS
Carefully unpack all parts.
Please note that additional items may be found
in the carton, depending on the letter suffix
following the catalogue number of your tool.
OVERVIEW (fig. A)
ASSEMBLY
To fit a screwdriver bit (6), push it into the bit
holder (2) until it locates.
To remove a screwdriver bit, pull it straight
from the bit holder.
USE
Let the tool work at its own pace.
Do not overload.
E N G L I S H
7