Cold Starting; Warm Starting; Maschine Stopping; Adjustement Oft He Cutting Side - Zipper Maschinen ZI-MOS125 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 42

Cold starting

Turn the choker into the position like shown in Fig. G. Put the slider (I-2) into START position
as shown in fig. I Put the throttle lever into idle run position by:
Pressing the throttle lock lever (I-1) with the palm of your hands downwards.
Pressing the throttle lever (I-4) upwards with your fingers.
Pressing the idle run lock lever (I-3) with your thumb downwards. Pull the starter cable grip
briskly outwards to start the engine 3-4 times. When the engine's running, you have to turn
the choker off again by bringing it back to OFF position. Now accelerate for the required rotation
speed (depends on the grass length and the driving speed) with the throttle lever (I-4).

Warm starting

Let the choker in OFF position.
Put the slider (I-2) into START position as shown in fig. I
Put the throttle lever into idle run position.
Pull the starter cable grip briskly.

Maschine Stopping

Place the machine where you have already mown the grass.
Put the throttle control lever into idle run position.
Put the slider (I-2) into STOP position as shown in fig. I

Adjustement oft he cutting side

You can choose from three horizontal cutting an-gles of mowing assembly. Left – middle – Right
position. This enables you to trim e.g. grass along fences and pathway borders conveniently! To
choose the horizontal cutting angle pull the locking bolt (Fig. K) upwards and swing the mow-ing
assembly into the desired position. Lock this position by releasing the locking knob again click-ing
into the respective hole.
17

MAINTENANCE

Hot surfaces and rotating machine parts while the engine is running can cause
serious injury or even death. Always stop the machine before carrying out any
conversion, adjustment, cleaning or maintenance work and secure it against
unintentional restarting.

Maintenance and Servicing plan

17.1.1 Table of Measures

What to do?
Check fuel level
Check for damaged parts
Checking for loose or lost screws
Air filter cleaning
Spark plug cleaning
The specified intervals refer to working under "normal" operating conditions. Depending on the
load, a change/exchange may also be necessary at an earlier point in time.
ZIPPER MASCHINEN GmbH
www.Zipper-Maschinen.at
ZI-MOS125
W A R N I N G
Frequency
before each start-up
before each start-up
before each start-up
every 25 h, replacement after 1 year
every 25 h; replacement after 1 year
MAINTENANCE
30

Publicité

Table des Matières

Dépannage

loading

Table des Matières