RCA RACE1202-B Manuel Du Propriétaire page 17

FIG.4A
Offset Inner sill
Interior
wall
Exterior
wall
Wooden Windows
2
Storm Window:
If the air conditioner is blocked by Storm Window, add wood
as shown in FIG.5, or remove storm window before air
conditioner is installed.
If Storm Window Frame must remain, be sure the drain holes
or slots are not caulked or painted shut. Accumulated Rain
Water or Condensation must be allowed to drain out.
Keep a firm grip on the air conditioner, carefully place the unit into the window opening
3
so the bottom of the air conditioner frame is against the window sill(FIG.6A & FIG.6B).
Carefully close the window behind the top rail of the unit.
FIG.6A
INSIDE
Extend the curtains out against the window frame (
4
(FIG.7B for Vinyl-Clad windows).
FIG.7A
Drive locking screws:
5
A: For wooden windows:
Drive screws(ST4X16FT) through the frame and into the sill (FIG.8A).NOTE: To prevent
window sill from splitting, drill pilot holes before driving screws. Drive (ST4X16FT) locking
screws through frame holes into window sash(FIG.8B).
16
All manuals and user guides at all-guides.com
OUTSIDE
Wooden Windows
window
frame
Installation
FIG.4B
Offset
Inner sill
Interior
wall
Exterior
wall
FIG.5
1-1/2min
(38mm)
INNER
SILL
INSIDE
FIG.6B
INSIDE
Vinyl-clad Windows
FIG.7A for wooden windows),
FIG.7B
Vinyl-clad Windows
Board thickness as
required, for proper
pitch to rear, along
entire sill.Fasten
with nails or screws.
STORM
WIDOW
FRAME
OUTER SILL
OUTSIDE
OUTSIDE