RCA RACE1202-B Manuel Du Propriétaire page 10

Operating Instructions
(continued)
Note: For Delay Stop , the unit must be in the On position.
First, press TIMER button, then adjust timer setting, tap or hold the UP ( ) or the DOWN arrow ( ) to
change delay timer at 1 hour increments, up to 24 hours. The time will be shown on the display, then the
control will automayically change the display back to the set temperature in 5 seconds.
Note: For Delay Start, the unit must be in the Off position.
First, press TIMER button, then adjust timer setting, tap or hold the UP ( ) or the DOWN arrow ( ) to
change delay timer at 1 hour increments, up to 24 hours. The control will count down the time remaining
until start (3,2,1,etc.). Press mode button to select modes, once energy saver or cool mode is chosen,
the set temperature defaults 79F(26℃). Press fan speed button to select fan speed.The display will
show the hours remaining until the unit start/stop. Pressing the unit On/Off button at any time will
cancel the Delay Start/Stop function. The Delay Start/Stop Feature will work until the unit either starts
or stops. Once that happens the above steps have to be repeated again.
SLEEP FEATURE:
SLEEP
FILTER REMINDER, YOU WILL SEE:
All manuals and user guides at all-guides.com
DO THIS:
PRESS
SLEEP BUTTON
Note:This feature is a reminder
to clean tne air filter (See Care
and Clean) for more efficient
operation. After 200 hours of
operation the display panel
will flashly displayCF to
remind you of cleaning the air
filter.
Operating Instructions
Note:Press the sleep button on the remote
control to start sleep function .
During cooling mode, the set temperature will
increase 2F(1℃) one hour after setting sleep
mode, and will increase 2F(1℃) once more in
the next one hour (that means the set
temperature increases 4F(2℃) within two hours
after setting sleep mode), then the air
conditioner will work at this temperature all along.
During sleep mode, fan speed will be "LOW".
fan speed button during sleep mode, the air
conditioner will stop sleep function.
can also be cancelled at any time during operation
by again pressing the "Sleep"button.
Press
The sleep mode
9