Kärcher Puzzi 10/1 Mode D'emploi page 8

Note: Warm water (max. 122°F/50°C) will
increase the cleaning effect. Verify the tem-
perature resistance of the surface to be
cleaned.
Note: For considerate treatment of the en-
vironment use detergent economically.
Fill up fresh water reservoir
 Fill detergent solution into the fresh wa-
ter reservoir. The fill level must not ex-
ceed the "MAX" mark.
Defoaming agent
Note: When cleaning previously sham-
pooed carpets, foam is generated in the
wastewater container. This formation of
foam can be prevented by adding a de-
foaming agent.
Puzzi 10/1 only:
 Put defoaming agent (optional accesso-
ry) into the wastewater container.
Puzzi 10/2 Adv only:
 Open container for defoaming agent.
 Fill in defoaming agent (optional acces-
sory).
Replacing the carpet adapter
 Push the unlocking device of the floor
nozzle on one side.
 Swivel out and remove the carpet
adapter.
 Insert a new carpet adapter and snap
the locking device in place.
Operation
Turning on the Appliance
 Plug in the main plug.
 Press the suction switch to turn on the
suction turbine.
 Press the spray switch to switch on the
spray pump.
Cleaning
Caution
Risk of damage. Check the object to be
cleaned prior to using the appliance in an
inconspicuous place for colour fastness
and water resistance.
8
All manuals and user guides at all-guides.com
 Operate the lever on the manifold in or-
 Run across the surface to be cleaned in
 In case of work interruptions, the floor
 Switch off the spray and suction switches.
 Pull out the mains plug.
 If the dirt water reservoir is full, switch
 Remove the lid.
 Remove the wastewater container from
 Turn off the appliance.
 Shortly activate the lever on bender to
 Separate bender from the spray/suction
 Insert the suction hose into the fresh
 Press the suction switch to turn on the
 Empty the fresh water reservoir and
 Remove the lid.
 Remove the wastewater container from
 Connect the manifold (with suction pipe
 Connect the coupling of the spray hose
 Fill approx. 0.5 gal (2 litres) of fresh wa-
 Press the spray switch to switch on the
 Hold floor nozzle over a drain.
 Activate lever on bender and flush the
 Turn off the appliance.
– 3
EN
der to spray the cleaning solution.
overlapping paths. Pull the nozzle back-
wards (do not push).
nozzle can be stored in the handle.
Turn off the appliance
Empty wastewater container
off the suction and spray switches.
the appliance and drain it.
Empty the fresh water reservoir
decrease the pressure.
hose.
water reservoir.
suction turbine.
switch the appliance off.
the appliance and drain it.
Flush appliance
and nozzle) to the suction hose.
with the manifold and snap in place.
ter into the fresh water reservoir.
Do not add any detergents.
spray pump.
appliance for appr. 1 to 2 minutes.