Publicité
Les langues disponibles
Les langues disponibles
6
Light Assembly Installation
4.
Carefully strip 6-inches (15.3 cm) of the outer cord jacket to expose the three
insulated conductors. Be careful not to damage the insulation on the three inner
conductors).
5.
Carefully strip a 1/2-inch (1.3 cm) of insulation off the three conductors. Be careful
not to damage the copper conductor.
6.
Connect all three conductors to the corresponding
circuit wires in the Junction Box
•
Black to Power
•
White to Common
Green to Ground
•
7.
Secure the Junction Box cover in place.
8.
Insert the Face Ring Tab into the slot in the bottom of
the niche.
9.
Tighten the pilot screw.
grounds the housing to the face ring and niche. Failure to
use the provided screw could create an electrical hazard
which could result in death or serious injury to pool/spa
users, installers or others due to electrical shock.
10. Fill the pool/spa until the light is completely
submerged in water before operating the light.
11. Check for proper light operation: To check for
proper operation, switch on the main switch or circuit
breaker, and the switch that operates the light itself.
The light should illuminate when power is applied.
INTELLIBRITE
Architectural Series Pool/Spa Light Installation and User's Guide
®
Only use the provided pilot screw.
This screw mounts and electrically
(cont.)
Pilot screw
Face Ring Tab
(hidden)
Pilot screw
Face Ring Tab
(hidden)
Publicité
