Publicité
Les langues disponibles
Les langues disponibles
Inserting and Removing the Tiller Wheels
Remove the battery from the unit before detaching the tiller wheels.
Please wear hand protection.
Run Direction!
Please observe the run direction of the tiller wheels!
1. Unscrew the hex nuts and remove the both tiller wheels.
2. Mount the new tiller wheels on the axle and observe the correct run
direction.
3. Re-tighten the hex nuts only hand-tight.
Angle Adjustment
The handle of the hand-tiller can be tilt to totally 3 angle positions (incl.
0° position).
Hold the unit on the handle and press the PUSH button inwards. Tilt
down or lift up the handle according to the working position you need
for the respective application.
Using the Extension Pole
1. Remove the battery (1) from the extension pole.
2. To extend the extension pole, release the lever (7). Pull out the
extension pole (8) up to the desired length and close the release
lever (7) again.
Operation
27
Publicité
