Télécharger Imprimer la page

Power Fist 8186306 Mode D'emploi page 5

Publicité

Les langues disponibles

Les langues disponibles

8186306
13. Do not repair leaking connections with sealant of any kind. Replace the O-ring or seal.
14. Do not disconnect the high-pressure hose from the pump and spray gun while the system is pressurized.
15. Always ensure that the spray gun, nozzles, and accessories are correctly attached.
16. Do not plug this pressure water into a hot water supply. This pressure washer is designed for cold water
use only.
17. To minimize the amount of water getting into the pressure washer, the unit should be placed as far as possible
from the cleaning site during operation.
18. Prior to starting the pressure washer in cold weather, be sure ice has not formed in any part of
the equipment.
19. Ensure the pressure washer is not covered during operation to avoid overheating the motor.
20. This pressure washer is capable of producing pressures up to 3,200 PSI. To avoid property damage and
personal injury, do not operate the pump with components rated for less than 3,200 PSI working pressure.
21. If connecting the pressure washer to a portable water system, ensure the water system is protected
against backflow.
GENERAL SAFETY PRECAUTIONS
Carbon Monoxide Poisoning
DANGER! Never start or run this engine indoors as exhaust contains carbon monoxide gas. Opening windows and
doors is not enough to ventilate the area.
Carbon monoxide is a colourless and odourless gas that is difficult to detect. Carbon monoxide poisoning results from
inhalation of the gas and may be lethal if left untreated. Evacuate all people to an area with clean air and seek immediate
medical attention for any person experiencing the following symptoms:
Headache
Confusion
Shortness of breath
Weakness
Fatigue
Dizziness
Unstable gait (stumbling around)
Nausea & vomiting
Unconsciousness
USE AND CARE OF TOOL
1. Use the correct tool for the job. This tool was designed for a specific function. Do not modify or alter this tool
or use it for an unintended purpose.
2. Do not carry the tool with fingers near or on the trigger/switch.
3. Avoid unintentional starts. Be sure that the ignition switch/trigger is in the neutral or OFF position when not in
use or before connecting it to any power source.
Visit www.princessauto.com for more information
3 GPM @ 3,200 PSI Gas Pressure Washer
V 3.0
5

Publicité

loading