Stopping Engine - RedMax EBZ8500 Mode D'emploi

EBZ8500/RH
8. Operation
■ ADJUSTING THE SHOULDER
F11
STRAPS
Tightening:
• Pull on the end of the strap.
F12 Loosening:
• Pull up on the lower portion of the
buckle with a finger and slide the end of
the strap back up to the buckle.
■ EMERGENCY REMOVAL
F13
• In an emergency, pull up on the lower
portion of both strap buckles to loosen
the straps. Move yourself away from
the unit.
■ ADJUSTING IDLE SPEED (F14)
F14
• The idling speed is set for 2000 rpm at
the factory. If it is necessary to adjust
the idle speed, use the adjustment
screw on the top side of carburetor.
(1) Idling Adjustment Screw
US-12

■ STOPPING ENGINE

F15 [EBZ8500]
[EBZ8500]
• Move the throttle lever to the idling
position and press the stop switch (red
button). The machine has the
mechanism that once the stop button is
pushed the plug won't give off sparks
until the engine stops. (F15)
(1) Stop Switch
F16 [EBZ8500RH]
[EBZ8500RH]
• Move the cruise control ignition switch
lever (RH) to the idling position and
then set it to the stop position. (F16)
(1) Cruise Control Ignition Switch
Lever (RH)
F17
If the engine won't stop when setting
the ignition switch to the stop position,
close the choke lever and stop the
engine.
In this case, please repair the machine
at your nealest servicing dealer. (F17)
(1) Choke Lever
(2) OPEN
(3) CLOSE
NOTE