Publicité
Les langues disponibles
Les langues disponibles
Replacing Activated Charcoal Filter
The Activated Charcoal Filters are not washable
and cannot be regenerated, and should be replaced
approximately every 4 months of operation, or more
frequently with heavy usage.
• Remove the charcoal filter by rotating it clockwise ( backwards)
until it unlocks from the motor housing and pull off sideways.
• To re-insert each charcoal filter, place up against the
side of the blower and push it inward. Then turn the
charcoal filter clockwise (forward) until it fits into place.
Caution: "When used in recirculation mode, to Re-
duce the Risk of Fire and Shock use only conversion
kit Model Charcoal Filter kit sku #901531; Durable
charcoal filter kit sku #901532"
Please contact the retailer that sold you the product to
purchase carbon filters above.
Cleaning
The stainless steel grease filters and grease rail
should be cleaned frequently in hot detergent
solution or washed in the dishwasher. Clean
exterior surfaces with a commercially available
stainless steel cleaner. Abrasives and scouring
agents can scratch stainless steel finishes and
should not be used to clean finished surfaces.
Make sure the grease filters are completely dry
with no water present before re-installing into
1. Use a drill to install side rails on the inside rangehood walls to
hood.
line the inside hood wall with stainless, 2 and 3 in FIGURE 26 with
9a. screws, 4 screws total.
Grease rail and Grease Filter Installation /
Removal.
Remove the plastic from the filter, the knobs
need to be installed onto the filter with 2
screws to each filter.
FIGURE 26
Install the grease rail into the back of the hood,
USE AND CARE INFORMATION
into the slots on the inside floor of the rear of the
This rangehood system is designed to remove smoke, cooking vapors
hood. The Grease filters should be installed before
and odors from the cooktop area.
operating the rangehood. To install the filters, use
Rangehood Control Panel
the two knobs to hold the filter and insert the filter
The control panel is located in the center of the hood bottom. The
into the front edge of the hood with the knobs
position and function of each control button are indicated in FIGURE
27
facing out into the spring loaded slot. Install the
other end of the filter above the grease rail in the
Light On/Off Button (A)
On/Off switch for the halogen lights. Position "0" turns the lights off,
back of the hood.
turning the switch to the right one click is the dimmer position, and
the next click to the right is full power
Blower On/Off Button (B)
On/Off switch for the blower. Move the dial to the right to turn the
blower ON and vary the speed of the blower. Turn to the left at "0"
to turn it OFF.
For Best Result
Start the rangehood several minutes before cooking to develop proper
airflow. Allow the unit to operate for several minutes after cooking is
ALL INSTALLATIONS
9a
9a
3
9a
9a
2
Replacing the Halogen Lamp
Before you begin, make sure that the rangehood is turned off and
that the other lamps have had sufficient time to cool. Halogen lamps
burn extremely hot and serious injury could result from touching a hot
lamp. Press and twist the lamp to remove. Then remove the lamp
and replace with a new lamp.
FIGURE 27
FIGURE 28
WIRING DIAGRAM
R11B41
A
B
LIGHT CONTROL
OFF / HALF LIGHT / ON
1
2
3
4
1
2
ON/OFF MOTOR
SPEED CONTROL
15
Publicité
