Publicité
Les langues disponibles
Les langues disponibles
Filters and FAA core washing instructions
For proper maintenance of your energy recovery core please follow these instructions
1
1
5
6
8
11
11
20
2
3
7
9
10
1
To remove the door, loosen both latches on
the bottom of the unit.
2
2
Rotate the metal plate holding the FAA core
in place.
3
Remove both filters. Wash filters in warm
soapy water then rinse and let dry.
4
Remove the core from the unit.
5
With one of your core's air inlets facing
down, place it in a large sink, bathtub, or
shower.
6
Pour clean tap water through the face of the
core facing upwards until it runs clear.
Ensure the entire surface is rinsed.
7
Rotate the core so that its other air inlet is
facing down and repeat step 5.
8
With plates still oriented vertically allow the
core to dry, normally 2-3 hours.
9
Replace the filter.
10 Slide back the core into the system making
sure that the arrow points to the motors.
Rotate the metal plate holding the FAA Core
in place.
11 Reattach the door.
9
12 Close the door, and secure both latches.
Publicité
