Power Fist 8160657 Mode D'emploi page 7

8160657
DISCONNECTING AIR SOURCE
WARNING! Failure to follow these steps could result in severe injury, tool or property damage.
Disconnect the HVLP paint gun from the air source before cleaning, servicing, changing parts /
accessories or when not in use.
1. Turn the air regulator to the OFF or L position.
2. Turn off the air compressor.
3. Disconnect the air pressure hose.
4. Discharge any residual pressure inside the HVLP paint gun.
UNPACKING
1. Carefully remove the HVLP paint gun from the package.
a. Retain packing material until you have carefully inspected and satisfactorily installed or
operated the HVLP paint gun.
2. Make sure that all items in the parts list are included.
3. Inspect the parts carefully to make sure the HVLP paint gun was not damaged while shipping.
OPERATION
1. To Start:
a. Use a spanner / wrench to tighten the nozzle.
b. Check for correct tightening of the paint cup to avoid any air leakage.
c. The air hose should be blown out before attaching the air connection to the paint gun and
air supply source.
d. Before using the HVLP paint gun, make sure that it is carefully flushed with solvent to
ensure a clean airflow.
2. Adjusting The Jet Width:
To adjust the jet width, rotate the fluid control knob adjuster. The spray pattern can be altered
from a flat to a round spray pattern as required.
3. Air Quality Control:
To set the air / material ratio, adjust the fluid control knob.
CAUTION! While under pressure, never remove the fluid control knob lock nut.
4. Internal Nozzle Pressure:
a. An entrance pressure of 63 PSI at the air inlet will create an internal nozzle pressure that
will exceed 10 PSI.
b. The best spray pattern is achieved at an internal nozzle pressure of 30 PSI.
Visit www.princessauto.com for more information
HVLP Paint Gun V 2.8
7