Power Fist 8160657 Mode D'emploi page 6

V 2.8
AIR COMPRESSOR
Ensure the compressor used with the HVLP paint gun can supply the required Cubic Feet per Minute at
the required PSI (see Specifications).
1. Use proper size and type of air pressure line and fittings
2. Use only clean, dry, regulated compressed air at the rated range as marked on the tool.
CAUTION! Do not use an air source besides an air compressor to power this tool.
3. Always use an air regulator, an in-line filter
and a moisture trap in your compressed
air system. These accessories will increase
the tool's life and keeps the tool in good
working condition. See the diagram for
recommended components of an airline.
4. Avoid using an air hose that is too long.
The longer the hose, the lower the pressure
that reaches the tool, possibly causing it to
cease functioning. As well, a longer hose
can become a tripping hazard.
5. Air Tool CFM consumption ratings are
based upon a 25% duty cycle. If you require
continuous duty, a larger compressor may
be required. See Specifications for the tool's
continuous duty limit.
AIR SOURCE INSTALLATION
WARNING! Never use pure oxygen, carbon dioxide, combustible gases or any bottled gas as an air
source for a tool. Such gases are capable of causing an explosion and serious injury to persons.
1. Set the air pressure regulator on the air compressor to 90 PSI. Do not exceed the HVLP paint
gun's recommended air pressure. Excess pressure could result in damage to the tool or serious
personal injury.
2. Prepare a standard 1/4 in. air connector for use with your tool. Wrap the threaded portion of
the air connector with thread seal tape. Wrap in a clockwise direction so it will not unravel when
attaching to a quick connector. Attach it to the HVLP paint gun's air inlet and tighten.
3. Attach a standard quick connector to the air source's hose. Attach the air hose to the tool's
air connector.
4. Check the air line and its connections for air leaks. Do not use the HVLP paint gun until you
have repaired all air leaks.
6
HVLP Paint Gun
For technical questions call: 1-800-665-8685
8160657