Publicité
Les langues disponibles
Les langues disponibles
8160657
SPECIFIC SAFETY PRECAUTIONS
1.
Wear proper breathing protection and a full-face shield that provides both frontal and
side protection.
2.
When using indoors, always make sure that the area is well ventilated.
3.
Use clamps or other practical ways to secure and support the work piece to a stable platform.
Holding the work piece by hand or against your body is unstable and may lead to loss
of control.
4.
Do not allow the spray to strike you and do not spray toward people or animals. Do not spray
the tool itself or any electrical sources.
5.
In order to eliminate the potential sources of fire; turn off the air compressor, all other
appliances and spark or flame sources while mixing paint.
6.
To minimize vapours in the spray area and eliminate all potential for spilling in the spray area:
a.
Tightly recap all containers immediately after mixing and store away from the spray areas.
b.
Do not operate the HVLP paint gun in the presence of open containers or spillage.
c.
Make sure all vapours have dispersed prior to turning the air compressor on.
7.
When spraying, ensure that there are no sources of ignition such as open fire, cigarettes, cigars
and pipe, spark, glowing wires, or hot surfaces in the area.
8.
Observe the wind direction when using the HVLP paint gun outdoors. When working indoors,
ensure that there is sufficient ventilation.
TOOL USE AND CARE
1.
Use the correct tool for the job. Maximize tool performance and safety by using the tool for its
intended task.
2.
Do not modify this tool or use for a purpose for which it was not designed.
3.
This tool was designed for a specific function.
Do Not:
a.
Modify or alter the HVLP paint gun; all parts and accessories are designed with built-it
safety features that may be compromised if altered.
b.
Use the HVLP paint gun in a way for which it was not designed.
4.
Securely hold this tool using both hands. Using tools with only one hand can result in loss
of control.
5.
Maintain tools with care. Keep tools clean and in good condition for a better and safer
performance. Follow instructions for changing accessories. Inspect tool fittings, alignment and
hoses periodically and, if damaged, have them repaired by an authorized technician or replaced.
The handles must be kept clean, dry and free from oil and grease at all times. A properly
maintained tool is easier to control.
6.
Avoid unintentional starts. Be sure that the trigger switch is in neutral or OFF position when not
in use and before connecting it to any power source. Do not carry the tool with fingers near or
on the switch.
7.
Disconnect the main plug from the air compressor when not in use, before servicing, and when
changing accessories on the tool or changing the paint canister.
Visit www.princessauto.com for more information
HVLP Paint Gun
V 2.8
5
Publicité
