Télécharger Imprimer la page

Bushnell 26-0100 Manuel D'instructions page 5

Masquer les pouces Voir aussi pour 26-0100:

Publicité

Les langues disponibles

Les langues disponibles

The Green LED indicates that the light amplifier unit is on. The Red LED indicates that the Infrared Illuminator is on. Always
remember to turn the unit off when done. Do not store this device while the indicators are lit. This device can be mounted on
any tripod with a 1/4" tripod socket (6).
Caution: This device can be used in extreme cold weather. However, when the unit is brought back into a warm environment,
you must wait approximately 5 hours before using the unit again. Damage may occur due to condensation that may have
accumulated on the internal circuitry of the unit.
Spots In The Image
You may see spots in the image. These vary from device to device and are cosmetic blemishes inside the device. These are
normal for Night Vision devices and are NOT a defect.
TROUBLESHOOTING
Scope will not turn on.
Check that the batteries are installed properly. Replace the batteries with new ones. Check the battery contacts to ensure they
are clean and free of corrosion. Check that the power is in the "ON" position.
Image is not focused.
Adjust the focus on the Eyepiece (5). Adjust the Objective Lens Focusing Ring. If still no improvement, clean the lenses; they
may be foggy or dusty.
Visibility decreases or disappears.
Bright light sources such as headlights may cause visibility to degrade or disappear completely. Turn the Power OFF (2) and turn
the scope away from the light source. The unit will restore itself in 1 or 2 minutes. Conditions such as fog or extremely dark
environments will decrease visibility.
Scope flashes.
The scope may flash when used in a bright environment. It may also flash during the first few seconds of use in dark environments.
7
All manuals and user guides at all-guides.com
CARE AND MAINTENANCE
Your Bushnell Night Vision device was designed to provide
many years of reliable service. To ensure that you get the
most enjoyment out of your Night Vision device, always obey
the following warning and precautions:
• Do not point this device toward any light source greater
than 1 lux such as car headlights, for an extended period of
time. This device utilizes an internal flash protection system
which minimizes potential damage, but long-term exposure
to bright lights can damage the unit. Any such damage
may void your warranty.
• This device was designed to be self-contained. Do not
open the body of the device or otherwise attempt to service
this device.
• Always store the device in a dry, well-ventilated room.
• Remove the batteries if the device is to be stored for longer
than 2 months.
• Keep the device away from any heating and air
conditioning vents or other heating devices, direct sunlight,
and moisture.
• Avoid dropping or otherwise shocking the unit. Although
designed for rugged outdoor use, this device incorporates a
sophisticated optical system, which could be damaged in
extreme cases of misuse.
• Clean
the
optical
lenses
with
professional
cleaning supplies.
• Clean the exterior of the device with a soft clean cloth.
Class 1 LED product per IEC 60825-1/nov 1993, appendix EN
60825-1A11/oct1996
TWO-YEAR LIMITED WARRANTY
Your Bushnell
®
product is warranted to be free of defects in materials and
workmanship for two years after the date of purchase. In the event of a
defect under this warranty, we will, at our option, repair or replace the
product, provided that you return the product postage prepaid. This
warranty does not cover damages caused by misuse, improper handling,
installation, or maintenance provided by someone other than a Bushnell
Authorized Service Department.
Any return made under this warranty
must be accompanied by the items listed below:
1) A check/money order in the amount of $10.00 to cover the
cost of postage and handling
2) Name and address for product return
3) An explanation of the defect
4) Proof of Date Purchased
5) Product should be well packed in a sturdy outside shipping
carton, to prevent damage in transit, with return postage
prepaid to the address listed below:
IN U.S.A. SEND TO:
IN CANADA SEND TO:
Bushnell Performance Optics
Bushnell Performance Optics
Attn.: Repairs
Attn.: Repairs
8500 Marshall Drive
25A East Pearce Street, Unit 1
Lenexa, Kansas 66214
Richmond Hill, Ontario L4B
2M9
For products purchased outside the United States or Canada please
contact your local dealer for applicable warranty information.
In Europe you may also contact Bushnell at: 33 141 44 94 80
Bushnell Performance Optics
Germany GmbH
lens
Morsestrasse 4
50769 - Cologne
Germany
* This warranty gives you specific legal rights.
You may have other rights which vary from country to country.
©2002 Bushnell Corporation

Publicité

loading

Ce manuel est également adapté pour:

26-0100w26-010226-0200