Publicité
Les langues disponibles
Les langues disponibles
3. Remove the spark plug.
4. Inspect the new spark plug. The spark plug must
be properly gapped and free of deposits in order to
ensure proper engine operation. The correct gap is
approximately 0.025 in. (0.64 mm). To widen gap, if
necessary, carefully bend the ground (top) electrode.
To lessen gap, gently tap ground electrode on a hard
surface.
5. Hand thread the new spark plug into the cylinder , turn-
ing it clockwise.
6. Tighten with a socket. (torque to 216 in.lb. [24.40 Nm]
minimum, 264 in.lb. [29.82 Nm] maximum.) Do not
over-tighten.
NOTICE:
Be careful not to cross-thread the spark plug.
Cross-threading will seriously damage the
product.
Storing the Product
1. Clean all foreign material from the product. Store unit
indoors in a dry, well-ventilated area that is inaccessible
to children. Keep away from corrosive agents such as
This Product Was Manufactured With A Catalyst Muffler
Congratulations! You have made an investment toward protecting the environment. In order to maintain this product's origi-
nal emission level, please refer to the maintenance section below.
Maintenance
Part
* CATALYTIC MUFFLER ASSEMBLY ................................................................................................................. X
* AIR FILTER ASSY
includes:
Filter .......................................................................................X
* CARBURETOR ASSY
includes:
Gaskets .......................................... X
* FUEL TANK ASSY
includes:
Fuel Lines ...................................... X
Fuel Cap ........................................ X
Fuel Filter ...................................................................................................................... X
* IGNITION ASSY
includes:
Spark Plug ..................................................................................................................... X
*NOTICE: THE USE OF EMISSION CONTROL COMPONENTS OTHER THAN THOSE DESIGNED FOR THIS
UNIT IS A VIOLATION OF FEDERAL LAW.
20
All manuals and user guides at all-guides.com
MAINTENANCE SCHEDULE
Inspect for
Damage Before
Each Use
garden chemicals, fertilizer, and de-icing salts.
2. Abide by all ISO and local regulations for the safe stor-
age and handling of gasoline.
When storing 1 month or longer:
1. Drain all fuel from tank into a container approved for
gasoline.
2. Run engine until it stops.
3. Place choke lever in the FULL CHOKE position.
4. Pull throttle lock back to lock the throttle.
5. Attempt to start the engine five (5) more times.
High Altitude Engine Operation:
Your engine is configured for operation below 2000 feet
altitude at the factory. Your engine must be re-configured
for operation above 2000 feet altitude. Operating the engine
with the wrong engine configuration at a given altitude may
increase its emissions, decrease fuel efficiency, degrade
performance and cause irreversible damage. Engines
configured for high altitude operation cannot be operated
in standard altitude conditions. A qualified service center
should ensure that your engine is properly configured for
your location.
Clean
Clean or Replace
Every
Every 25 Hours
5 Hours
or Yearly
Replace
Every
125 Hours
Maintenance
Publicité
