Inventum IKI9021 Mode D'emploi page 28

38
CONNECTING THE HOB TO THE ELECTRICAL SYSTEM
• Connect the hob according to the wiring diagram. This device is set for three phase, three phase (400V)
and uses a special 5-pin plug. The connection cable must have a cross-section of at least 2.5 mm ². The
connection must be performed by a qualified installer. The hob does not include a connection cable and a
Perilex plug.
• The socket for connecting to the electrical system must be provided with an earthing pen and may not be
located above the hob. The socket for connecting to the electrical system must also be accessible for the user
after placement of the hob.
• Before connecting the hob, check that:
- the fuse and electrical system are suitable for the load of the hob,
- the electrical system is equipped with an efficient earthing system that meets the current standards
and regulations.
- the socket is easily accessible.
ATTENTION : this hob is not suited for a different wiring diagram.
5x2,5 mm² 3N~
28 • English
38