Publicité
Les langues disponibles
Les langues disponibles
VI. INSTALLATION
5. Place front skid plate (A1) on to vehicle. Align
skid plate with middle skid plate (A2) and vehicle
frame. Use clamps to temporarily hold skid plate
in place. See Figure 3.
6. The mounting locations will need to be drilled.
Adjust skid plates locations to ensure best fit to
vehicle Use a center punch to mark the center
location of the mounting holes and use an 11/64"
drill bit to create the mounting hole. Install #12
screws (B1) in these locations.
7. Place rear side skid plate (A4) on to vehicle.
Align skid plate with rear skid plate (A3) and
vehicle frame. See Figure 4.
8. Drill hole mounting locations and install screws
(B1) to secure skid plate to vehicle.
9. Remove fasteners shown in Figure 5.
10. Place skid plates (A9, A10) onto vehicle. Use C-
clamps to assist positioning skid plates if
necessary. See Figure 6.
WARN INDUSTRIES
©2007 Warn Industries, Inc.
WARN® and the WARN logo are trademarks of Warn Industries Inc.
Pull plastic out towards skid plate while
PAGE 6
Figure 4
Remove Fasteners
Figure 5
tightening skid plate screws
Figure 6
78165A1
Publicité
