Skil LT4823B-00 Guide D'utilisation page 13

3. Press the front-assist handle onto the shaft
and assemble the hex bolt with the wing
nut. Turn the front-assist handle upward
so that it points toward the top of the rear
handle (Fig. 7).
4. Adjust the front-assist handle position so
that it is between the rear handle housing
and the hinge of the shaft, as shown in Fig.
8. The handle should be adjusted so that
your front arm is straight when using the
trimmer.
5. Tighten the wing nut so that the handle
cannot be rotated on the shaft.
Fig. 7
Fig. 8
13