Skil LT4823B-00 Guide D'utilisation page 21

5. Remove the nut, spool assembly, upper cover, and shroud from the motor shaft (Fig. 23).
6. Replace with a new trimmer head and mount it as follows:
Fig. 23
Shroud
Install the New Trimmer Head
1. Mount the shroud assembly, the upper cover, spool assembly, and washer in that order.
Use an impact wrench on the nut to tighten it.
2. Following steps 4 and 5 in "Reload the Cutting Line" section in this manual, to mount the
lower cover assembly.
3. Follow the instructions in "Line Replacement" section in this manual, to reload the cutting
line.
4. Start the tool to see whether the string trimmer works normally. If it does not, reassemble
as described above.
Upper Cover
Cutting Line
Washer
Spool Retainer
Lower Cover
Assembly
Nut
Spring
21