Tips For Best Trimming Results - Skil LT4823B-00 Guide D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

To Use the String Trimmer
WARNING
dusty locations .
WARNING
from the unit.
WARNING
entangled in the cutting attachment.
WARNING
to bystanders from thrown objects; bystanders should be encouraged to wear eye protection.
If you are approached, stop the motor immediately.
Check for Damaged/Worn Parts before Each Use .
Check the trimmer head, guard, and front-assist handle. Replace any parts that are cracked,
warped, bent, or damaged in any away.
The line-cutting blade on the edge of the guard can dull over time. It is recommended that you
periodically sharpen it with a file or replace it with a new blade.
WARNING
guard and protect your hand from injury.
Clean the Trimmer after Each Use
See the Maintenance section for cleaning instructions.
WARNING
of commercial solvents. Use clean clothes to remove dirt, dust, oil, grease, etc.

Tips for Best Trimming Results

(Fig . 14)
1. The correct angle for the cutting attachment
is parallel to the ground.
2. Do not force the trimmer. Allow the very
tip of the line to do the cutting (especially
along walls). Cutting with more than the
tip will reduce cutting efficiency and may
overload the motor.
3. The cutting height is determined by the
distance of the cutting line from the lawn
surface.
4. Grass should be cut by working
progressively from top to the bottom in
small increments to avoid premature line
wear or motor drag.
5. Slowly move the trimmer into and out of the area being cut, maintaining the cutting head
position at the desired cutting height. This movement can be either a forward-backward
motion or a side-to-side motion. Cutting shorter lengths produces best results.
6. Trim only when grass and weeds are dry.
To avoid serious personal injury, wear goggles or safety glasses at
all times when operating this unit . Wear a face mask or dust mask in
To prevent serious personal injury, remove the battery pack from the tool
before servicing, cleaning, changing attachments or removing material
Clear the area to be cut before each use. Remove all objects, such as
rocks, broken glass, nails, wire, or string that can be thrown or become
Clear the area of children, bystanders, and pets . Keep all children,
bystanders and pets at least 100 ft . (30 m) away . There still may be risk
Always wear gloves when mounting or replacing the guard or when
sharpening or replacing the blade . Note the location of the blade on the
Never use water to clean your trimmer. Avoid using solvents when cleaning
plastic parts. Most plastics are susceptible to damage from various types
Fig. 14
Danger Cutting Area
Best Cutting
Area
17

Publicité

Table des Matières
loading

Table des Matières