Publicité
Les langues disponibles
Les langues disponibles
4. Precautions & Recommendations
4.1 Operation Tips
1. Installation and maintenance shall be done by professional technicians. If necessary, contact the technicians.
Grounding connection of the device must comply with the local regulations. (Warning: Improper operation,
installation or maintenance may cause property damage, injury or death etc.. Read this instruction manual
thoroughly before installing, operating or servicing this equipment.)
2. All operators should observe the electric safety regulations strictly. Before using, making sure that the power
voltage complies with that on the nameplate and the grounding is safe.
3. All operations should be done only in safe condition. If any failure occurs, have it repaired immediately.
4. This product needs to be operated by trained cook. Do not dismantle or self-modify the machine.
Dismantlement and self-modification may cause casualty.
5. Before cleaning, unplug and cut off the power supply. During cleaning, do not aim at the appliance with
water jet. Water may conduct electricity, that may cause electric shock due to leakage.
6. Do not pat the product or put any heavy objects onto it. Abnormal operation may cause damage and danger.
Do not touch the appliance with hands directly due to high temperature during or after operation, especially
the hot area with high temperature which may cause scald.
7. Do not use extra power supply that not marked on the product.
8. Do not use power knife that not conforming to safety standard.
9. To prevent damage, turn off the switch ASAP when near the thunder zone.
10. Do not destroy the furnace surfaces with hard or sharp objects.
11. After working, turn off the switch.
12. Circuit installation and maintenance shall be done by qualified technicians.
13. If the power cord is damaged, to avoid hazard, substitution should be done by manufacturer or its
maintenance department or similar professional personnel.
14. Do not aim at the electrical box with water directly, nor do immerse it into water for cleaning.
4.2 Storage & Transport
1. The packaged device should be stored in a well-ventilated warehouse without any corrosive gas instead of
exposing to the open air. Should any temporary storage needed, please take measurement against raining.
2. For safety sake, this device has already been checked by qualified personnel before transportation. Please
take care when handling it. Please check the delivery upon completeness and transport damage immediately
after receipt. In case of visible damage, do not accept. The carrier takes full responsibility for the damages
caused during transportation. Hidden damages should be reclaimed immediately after notice, as claims for
damages can only asserted within the effective period for complaints.
3. During transportation, the machine should be carefully handled, do not put it upside down to prevent from
damaging the shell and inside.
4.3 Installation
1. The supply voltage should comply with the working voltage of the appliance. The appliance is equipped with
copper equipotential terminals at lower back of the box, which should be connected with copper wire no
less than 1.5mm² reliably as prescribed. After installation, check that whether the connection is loose,
whether the voltage is normal and whether the safety grounding is reliable. The fixed arrangement of wire
should be equipped with an all-pole disconnecting switch with a contact opening of 3mm on its poles. It is
advisable to install a grounding leakage protection switch or relay that with a leakage peak of 10mA.
Mounting space for the device shall be at least: 1500x850x530 mm (LxWxH). Unpack the device and place
it on the floor.
2. Electrical Connection:
•
The supply voltage should comply with the working voltage of the appliance.
The appliance is equipped with an earth bolt at its back, which should be connected with copper wire
•
no less than 1.5mm² and earth wire that conforming to safety regulations reliably.
The fixed arrangement of wire should be equipped with an all-pole disconnecting switch with a contact
•
opening of 3mm on its poles. It is advisable to install a grounding leakage protection switch. Do not pile
up sundries in front of the switch, for convenient operation sake.
www.combisteel.com
7
Publicité
