Publicité
English
Safety Information
WARNING!
Failure to understand and
comply with safety regulations may result
in serious injury or death. Regulations
included herein are not all-inclusive, are
for reference only, and are not intended
to replace a Competent Person's
judgment or knowledge of federal or state
standards.
CAUTION!
Understand the definitions
of those who work near, or who may be
exposed to, fall hazards.
WARNING!
Use of equipment in
unintended applications may result
in serious injury or death. Maximum 1
attachment per connection point.
Do not alter or misuse equipment.
Workplace conditions, including, but not limited
to, corrosive chemicals, electrical shock, sharp
objects or edges, machinery, flame/high heat,
abrasive or uneven surfaces, UV exposure, and
severe or prolonged weather conditions, must be
assessed by a Competent Person (CP) before fall
protection equipment is selected. The presence
of any/all of these conditions may have negative
effects on product performance or service
lifetime.
The analysis of the workplace must anticipate
where workers will be performing their duties,
the routes they will take to reach their work, and
the potential and existing fall hazards they may
be exposed to. Fall protection equipment must
be chosen by a CP. Selections must account for
all potential hazardous workplace conditions. All
fall protection equipment should be purchased
new and in an unused condition.
Fall protection systems must be selected and
installed under the supervision of a CP, and
used in a compliant manner. The system must
be designed in a manner compliant with all local
safety regulations. Forces applied to anchors
must be calculated by a CP.
85627 REV. E
Harnesses and connectors selected must be
compliant with manufacturer's instructions, and
must be of compatible size and configuration.
Snap hooks, karabiners, and other connectors
must be selected and applied in a compatible
fashion. All risk of disengagement must be
eliminated. All snap hooks and karabiners must
be self-locking and self-closing, and must never
be connected to each other.
See Diagram B on page 20
A pre-planned rescue procedure in the case
of a fall is required. The rescue plan must be
project-specific. The rescue plan must allow
for employees to rescue themselves, or provide
an alternative means for their prompt rescue to
minimise post fall suspension time. Store rescue
equipment in an easily accessible and clearly
marked area.
Training of Authorised Persons (APs) to
correctly erect, disassemble, inspect, maintain,
store, and use equipment must be provided
by a CP. Training must include the ability to
recognise fall hazards, minimise the likelihood of
fall hazards, and the correct use of personal fall
arrest systems.
NEVER use fall protection equipment of any kind
to hang, lift, support, or hoist tools or equipment,
unless explicitly certified for such use.
Equipment subjected to forces of fall arrest must
immediately be removed from use.
Age, fitness, and health conditions can seriously
affect the worker should a fall occur. Consult a
doctor if there is any reason to doubt a user's
ability to safely withstand fall arrest forces or
perform set-up of equipment. Pregnant women
and minors MUST NOT use this equipment.
Physical harm may still occur even if fall safety
equipment functions correctly. Sustained post-
fall suspension may result in serious injury or
death. Use trauma relief straps to reduce the
effects of suspension trauma.
15
Publicité
