Orbegozo CP 91120 Manuel D'instructions page 15

CP 91120
OPERATING THE FAN
- Select the fan speed by pressing the speed control button on the remote
control transmitter :
HI: High Speed MED : Medium Speed LOW : Low Speed OFF : Off
- The switch on motor housing for controlling the fan blades rotating
direction controls the direction of air movement.
- Caution : Before using this rotating direction switch, turn OFF the fan and
ensure the fan stops rotating to prevent injury to yourself and damage to
the moto.
- Cold weather: Push the switch 'UP' so that the blades will bring the warm
air trapped near the ceiling fan to move downwards throughout the room.
- Hot weather: Push switch 'DOWN' so that the blades will create a breeze
and circulate the air to the room.
- Pressing the 'ON/OFF' light button on the remote control transmitter can
control the turning on or off of the light.
REMOTE CONTROL
- Use the remote control transmitter to change the speed of the fan and
to switch the light and fan on or off.
- Replace the batteries by sliding the battery compartment cover on the
remote control transmitter in the direction of the arrow, fit 1 x A23 12v
battery
(Note : Batteries NOT included).Re-assemble the battery compartment
cover.
- Always ensure the battery compartment cover is closed properly.
- Don't expose the remote control to direct sunlight.
- Don't attempt to recharge expired batteries. There are special
rechargeable batteries, which are clearly marked with.
- Don't dispose of batteries in fire to avoid explosion.
REMOTE CONTROLLER OPERATION:
Point the remote at the infrared sensor to power the fan.
15