Kingston Technology DataTraveler Locker+ G3 Manuel D'utilisation page 20

USB   Cloud Initialization (Mac Environment)
Once the device has been initialized, the USB-to-Cloud
application will appear as seen in to the right.
Figure 7.7
Please make sure you have a working Internet connection
before you continue.
To proceed with the installation, click the green 'Accept'
button in the bottom right-hand corner of the clevX window.
To decline the installation, click the red 'Decline' button in the
bottom left-hand corner of the clevX window.
(Note: If you click the red 'Decline' button, it will cancel the
USB-to-Cloud installation. In doing so, a special file named
'DontInstallUSBtoCloud' is created on the data partition. The
presence of this file will prevent the application from
prompting you for the installation in the future.)
Figure 7.7 – USB-to-Cloud
Once the installation has completed, you will
see an application box with a list of options to
choose from (for syncing your DataLocker+
G3 data.)
Figure 7.8
Select the cloud option you wish to use as
your backup application and provide the
necessary credentials required for
authentication.
(Note: If you currently do not have an account
set up with any of the cloud options listed, you
may create one at this time, using your
favorite Internet browser, and then completing
Figure 7.8 – Cloud Options
this option afterwards.)
Once you've chosen a cloud option and
authenticated to the corresponding service,
the USB-to-Cloud program will perform an
initial comparison of the data partition against
what is stored in the Cloud. As long as the
USB-to-Cloud service is running in Task
Manager, content written to the data partition
will automatically back up (sync) to the Cloud.
Document No. 480G3001-001.A06 DataTraveler ® Locker+ G3 USB-to-Cloud Page 19 of 28