Publicité
Les langues disponibles
Les langues disponibles
OPERATION
6.
Push the roller out.
7.
Remove the roller.
8.
Now insert the desired roller into the device so that it fits into the mount and push it to
the left.
9.
Turn the lever by 90°C in any direction to fix the roller in place.
Adjusting the working depth (Fig. L)
Risk of damage!
If the working depth has been wrongly set, the roller or the soil can become damaged.
It is useful to adjust the height adjustment when you want to transport the scarifier.
The height adjustment also lets you set the working depth for your lawn. At the time
of delivery, the scarifier is set to a working depth of 3 mm ("+ 3").
-
Set the height adjustment to position "+ 10" (parked position/ transport position) to
transport or park the device.
-
Set the working depth to the desired position to carry out the following work with the
device.
Scarifying (scarifier roller)
When scarifying, the roller should cut 3 to 5 mm into the soil. Deeper penetration harms the
sod.
-
Position "- 3" with new roller
-
Position "- 6" with slightly used roller
-
Position "- 9" for readjusting with increasing wear.
Aerating (aerator roller)
-
Position "- 3" in case of slight to average thatching
-
Position "- 6" in case of heavy thatching
The aerator roller must never be operated in the positions "- 9". This can lead to substantial
damage to the sod, the aerator roller and the device.
Preparing for operation
1.
Check the device, the collecting bag and the blade before switching the device.
2.
Set the desired working height before switching the device.
3.
Check the handle position (height) and correct it if necessary to work comfortably.
24
OPERATION
Switching the motor ON and OFF (Fig. M)
The motor is activated with a safety switch. When you let go of the safety bar, the motor
stops. Only turn on the motor on the grass.
1.
Place the device on the grass.
2.
Press and hold the ON/OFF switch.
3.
Pull the safety bar towards the handlebar.
4.
Let go of the start button and keep the safety bar pressed to the handle as long as you
want to keep the motor running.
To stop the motor, let go of the safety bar.
Caution: The roller might continue to keep turning. Wait until the roller stands still before
working on the device.
LED indicator (Fig. N)
This device equipped with a LED indicator on the switch box. Battery capacity will shown by
pressing the button.
NOTE: The 4 LED will be flashing with a long beep when encounters an overload situation.
This overload indicator should help not to harm your lawn.
Emptying the collecting bag
The cuttings (thatch and moss) make excellent compost materials. Mix the grass and moss
cuttings with other garden waste (e.g. brushwood) so that these don't mat together.
1.
Stop the motor and wait until the roller stands still.
2.
Lift the discharge flap.
3.
Lift the collecting bag off the device. Slightly lifting the collecting bag releases it.
4.
Hold on to the discharge flap and move it until the discharge chute is covered again. Do
not simply let go; the discharge flap may get damaged due to the spring action.
5.
Empty the collecting bag completely and make sure that it is not damaged. Clear the
lawn thatch material off the fabric as best as possible so air can flow properly through
the fabric.
6.
Attach the collecting bag (see section "Attaching the collecting bag")
25
Publicité
