Trust START-LINE AGST-8802 Mode D'emploi page 6

5c. Open/Stop/Close
1. Press the ON button to open the blinds. Press the ON button again to stop the blinds.
2. Press the OFF button to close the blinds. Press the OFF button again to stop the blinds.
Read the manual of the receiver to reverse the direction of the blinds.
5d. Activating wireless doorbell
Press the ON button to activate the melody of the wireless doorbell.
For more information, see the manual of the receiver
Replace battery
A
Use a flathead screwdriver to remove the button first.
B
Then place the flat screwdriver in the recess of the frame and lift the screwdriver to unclip the
frame from the back plate. Remove the rubber protector.
C
Remove the battery by inserting the flat screwdriver into the slot and sliding the battery out.
D
When replacing the push button, make sure that the recess of the push button is on the same side
as the recess of the frame
Insert a new CR2032 battery. Make sure the + side is facing up. The wireless wall switch is now ready
for use again.
Unpair wireless wall switch
To unpair the wall switch put the receiver into learning mode. When the receiver is in learning mode
give an OFF signal with the wall switch. The receiver will give a confirmation that the wall switch is
unpaired.
The receiver can no longer be operated with the wall switch.
Clear the memory of the receiver
Consult the manual of the receiver to erase its memory.
AGST-8802 OUTDOOR WIRELESS DOUBLE WALL SWITCH
EN
2