Navman W100 Manuel D'utilisation page 8

Wiring Connection
• Keep electrical and transducer cables away
from alternator or other noise generating
electrical cables. Avoid connecting the
instrument to power circuits that share
loads with ignition, alternators, inverters and
radio transmitters. Electrical power supply
connections should always be as short as
possible.
Fuji
Plug &
Red
Socket
Black
Green
Blue
Wind
Transducer
6
Fuji
Plug &
Red
Socket
Black
Green
Blue
Wind
Transducer
NMEA data to Wind
• Connect the red wire to the positive supply
via a 1 amp fuse or a 1 amp circuit breaker.
Connect the black wire to the electrical
ground. A 1 amp fuse will provide protection
for up to five 100 series instruments.
• Connect the 5 pin Fuji connector to the
wind transducer cable connector. Do not cut
or shorten the transducer cable. Extension
cables are available if the transducer cable
is too short.
• If you are not interfacing to a NAVMAN
S100 speed instrument or NAVMAN R100
repeater or you do not intend to provide
NMEA data to another instrument then
insulate the bare unused wires in the end of
the five core cable.
1A Fuse
NMEA data to Wind (from Speed/Log)
NMEA output to repeater
Multiple Instruments
The model NAVMAN W100 wind
instrument can be connected to
the model NAVMAN S100 speed
instrument to display true wind
speed direction and speed VMG
data on the NAVMAN W100 display.
The NAVMAN W100 may also be
connected to the NAVMAN R100
system repeater or to any other
instrument that will accept standard
NMEA 0183 data.
Red
Black
Blue
Speed
Transducer
+12 VDC
Ground
1A Fuse
+12 VDC
Ground
NMEA speed data to repeater
NMEA wind data to repeater
NAVMAN W100 User Manual