Table Des Matières; Important Safety Instructions - Jung Pumpen MULTICUT G2D-01 Manuel D'installation

Safety
Contents
Important Safety Instructions . . . . . . . . . . . . . . . . . . . . . . .2
Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3
Electrical . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
Control Panels . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5
Operation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .5
Maintenance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .6
Seal Lubrication . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6
Troubleshooting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .8
Repair Parts . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .9
Product Specifications . . . . . . . . . . . . . . . . . . . . . . . . . . . .11
Warranty . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .11

Important Safety Instructions

SAVE THESE INSTRUCTIONS - this manual contains
important instructions that should be followed during
installation, operation, and maintenance of the product.
save this manual for future reference.
this is the safety alert symbol. When you see this
symbol on your pump or in this manual, look for one of
the following signal words and be alert to the potential
for personal injury!
indicates a hazard which, if not avoided, will
result in death or serious injury.
indicates a hazard which, if not avoided,
could result in death or serious injury.
indicates a hazard which, if not avoided,
could result in minor or moderate injury.
NOTICE addresses practices not related to personal injury.
the manufacturer cannot anticipate every possible
circumstance that might involve a hazard. the warnings
in this manual, and the tags and decals affixed to the unit
are, therefore, not all-inclusive. If you use a procedure
or operating technique that the manufacturer does not
specifically recommend, you must satisfy yourself that it
is safe for you and others. you must also make sure that
the procedure or operating technique that you choose
does not render the system unsafe.
electrically powered sewage pumps normally give many
years of trouble-free service when correctly installed,
maintained, and used. However, unusual circumstances
(interruption of power to the pump, large solids in
the sump, flooding that exceeds the pump's capacity,
electrical or mechanical failure in the pump, etc.) may
prevent your pump from functioning normally. to prevent
possible damage, consult your dealer about installing
a secondary sewage pump or a high water alarm. see
Troubleshooting in this manual for information about
common sewage pump problems and remedies. For
more information, see your retailer, call Jung pumpen
customer service at 1-800-642-5930 or visit our web site
at jungpumpen-us.com.
Risk of electrical shock . shock can cause
serious injury or death. Failure to follow the warnings
below can result in fatal electric shock.
Risk of electrical shock . during operation
the pump is in water:
• Check your local codes before installing. You
must comply with their rules. only qualified
personnel should install the pump and associated
control equipment.
• Ground the pump according to all applicable codes
and ordinances.
• Take care when changing fuses or resetting the
circuit breaker. disconnect power to the pump
before servicing. do not stand in water when
working on the control box or with the circuit
breaker panel.
• This pump is intended for permanent connection
only. do not connect conduit to pump. provide a
strain relief at the control box for the power supply
cord connection to box. all control components
must be ul or csa listed and suitable for end use
application.
• Do not remove cord or strain relief. Do not lift the
pump by the power cord (see Cord Lift Warning).
2