Publicité
Les langues disponibles
Les langues disponibles
OPERATING INSTRUCTIONS
WIRELESS CONNECTION
This appliance can be controlled with a wireless
application on your wireless device.
Visit https://www.danby.com/support/apps to
download the application and learn about its
operation.
TIMER
Press the timer button while the air conditioner is
running to set the auto off timer. Press the timer
button while the air conditioner is not running to set
the auto on timer. For some units continuing to press
the timer button will cancel the timer settings.
Press the temperature control buttons to change
the set time by 0.5 hour increments up to 10 hours
and then at 1 hour increments up to 24 hours. The
display will count down the time remaining.
The selected time will register in 5 seconds and the
system will automatically revert back to display the
previous temperature setting or room temperature.
Turning the appliance on or off at any time or
adjusting the timer setting to 0 will cancel the timer
settings.
SLEEP
Press the sleep button to initiate the sleep feature
which will conserve energy during sleeping hours.
This feature is available in cool mode.
When selected, the set temperature will increase
by 2° 30 minutes after sleep mode is initiated.
30 minutes later, the temperature will increase by
another 2°. The new temperature will be maintained
for 7 hours before the appliance returns to normal
operation.
The sleep feature can be canceled at any time by
pressing the sleep button.
ECO
The ECO feature is available in cool, dry and auto
modes. The fan will continue to run for 3 minutes
after the compressor shuts off. The fan then cycles
on for 2 minutes in 10 minute intervals until the
room temperature is above the set temperature and
the compressor turns back on. This will minimize
how often the compressor turns on.
LOCK
On the remote control, press and hold the LED and
the C°/F° buttons at the same time for 5 seconds
to activate the control panel lock. Buttons on the
control panel and the remote control cannot be
pressed when the control panel lock is active.
Press and hold the LED and C°/F° buttons at the
same time for 5 seconds to deactivate the control
panel lock.
19
Publicité
