Victron energy SmartSolar MPPT 150/35 Manuel page 6

1.3. Symboles utilisés sur le boîtier
Les symboles suivants sont utilisés sur le boîtier du chargeur solaire :
Symbol Nom
e
Avertissement de risque
d'électrocution
Avertissement de surface
chaude
Lire les instructions du
manuel
Indice de protection
Symbole de mise à la terre
1.4. SmartSolar MPPT 150/35 FCC and Industry Canada Compliance
This device complies with part 15 of the FCC Rules and to RSS of Industry Canada.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired operation.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation
est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit
accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.
Changes or modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a commercial
environment. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. Operation of this equipment in a residential area may cause radio
interference, in which case the user may be required to take adequate measures. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This Class A digital apparatus complies with Canadian ICES-003.
Page 2
Manuel du chargeur solaire MPPT
Signification
Ne pas toucher les raccords électriques, il y a un risque d'électrocution.
Ne pas toucher la surface de l'appareil lorsqu'il est en marche, car elle peut
être chaude.
Lisez le manuel du produit avant de l'installer et de l'utiliser.
IP43 - Les composants électroniques sont protégés contre les outils et les
petits fils de plus d'un millimètre et contre les projections d'eau à moins de
60 degrés de la verticale.
Indique la position de la connexion de mise à la terre du châssis
Précautions à prendre !